Sheetmetal using Creo Parametric

In this course, you will learn how to create sheetmetal parts in Creo Parametric. The course builds upon the basic lessons you learned in Introduction to Creo Parametric 7.0 and serves as the second stage of learning. In this course, you will learn how to design sheetmetal parts and assemblies, including sheetmetal production drawings. All the functions needed to create sheetmetal parts, drawings, and assemblies are covered. Upon completion of this course, you will be able to create sheetmetal design models, create the flat state of the model, and document both in production drawings.

At the end of each module, you will complete a set of review questions to reinforce critical topics from that module. At the end of the course, you will complete a course assessment in PTC University Proficiency intended to evaluate your understanding of the course as a whole.

This course has been developed using Creo Parametric 7.0.

Course overview

Day 1

  • Module 01 – Introduction to the Creo Parametric Sheetmetal Design Process
  • Module 02 – Sheetmetal Model Fundamentals
  • Module 03 – Creating Primary Sheetmetal Wall Features
  • Module 04 – Creating Secondary Sheetmetal Wall Features
  • Module 05 – Bending and Unbending Sheetmetal Models

Day 2

  • Module 06 – Sheetmetal Form Features
  • Module 07 – Modifying Sheetmetal Models
  • Module 08 – Sheetmetal Setup and Tools
  • Module 09 – Detailing Sheetmetal Designs Module 10 – Design Project

    Fill in the form below to book a training session.











    PLM Central values each enquiry. We will respond to you within 24 hours, guaranteed.